Troubleshooting Girard On Demand Water Heater

Do not turn on the cold water.

Troubleshooting girard on demand water heater.

Increase the low to lower the temperature and decrease the flow to raise the temperature. Confirm that the plastic tube is connected to the blower and pressure switch. Often this issue is caused by the gas supply so check to make sure your propane tank is full before you do anything else. If your gas valve or water valves are not fully opened this could also cause the ignition to fail.

Drill a hole and then run 2 18 gauge wires from the rear of water heater to the hole maximum wire length is 16 or 5m. Since the girard tankless water heater does not have a tank it does not need to pre heat and store water to 130 to 140 degrees. Reset and check the microprocessor verify that it does not have the flame ensure that the switch is opening the blower is turning on once you detect the combustion air flow you need to open the gas valve and supply the first. Check the lock nut at the bottom of the blower where the plastic tube attaches.

On the girard tankless water heater the user turns on only the hot water open to a normal flow and then gradually adjusts the flow to achieve the desire temperature usable hot water. Our on demand tankless rv water heater was developed with state of the art electonics and components. Water heater comes on and then give e 8 code air pressure switch. Based on there the circuit board will be able to complete the tasks.

I believe my water pump is a 3 8 gpm unit. Confirm that nothing is blocking the exhaust vent. For unique green rv products to enhance your outdoor experience call 1 866 559 1221 or e mail us. Connect the 2 wires to the user control panel 2 wires and to the 2 wires on rear of water heater ucp wires are blue or blue green.

Check and open gas and water valves fully. Update on my girard water heater. Contact your girard dealer or service center if you can t achieve the proper temperatures rises. The mode switch should be set on high.