Slide the door over.
Take sliding door off track.
Look at the bottom of each closet door to locate wheels that rest on the bottom track.
Insert the screwdriver at the bottom to lift the rollers from the track.
Note that the rollers of the door shown here reside up inside a.
3 remove the rollers.
Taking the door out of the track 1.
If your sliding glass doors don t have the screen door then you may move on to the next step.
Pull the door up from the bottom track until the wheels are out.
Open the door and ask your helper to slightly lift the screen door.
In this photo you can see the large round screw head that is.
Loosen every single screw to ensure that you don t miss one and crack your.
Wiggle the door until the pivot snaps into the hole.
Bring the door to within a few inches of the strike side jamb.
Find the adjustment screw and rotate it with a screwdriver phillips or slotted depending on model to bring.
Once secure release the door.
Moving the door when the back side is sliding on the ground is a little difficult.
Loosen the screws at the top of both doors.
Kung fu maintenance demonstrates how to replace some wheels that are not rolling right on a patio slider door that is coming out of it s track and not rollin.
Even if you have brackets on the bottom of your door they re probably just connected to your wheels.
Dirt mud hair and fur can collect along the track and in the groove which clogs the rollers underneath and prevents smooth motion.
Work the door slowly into the opening in this manner.
Once the door is approximately under the hole in the track release the pivot.
Hold down the spring loaded guide on the opposite side of the other door panel and swing the door until the guide is under the track.
Try holding your foot against the bottom of the door and pull gently on the top of the door to lift the back side.
Sliding patio doors have two separate units namely the sliding door panel and the stationary panel.
Here s how you can clean the rollers and the track.
To remove the screen door use a flathead screwdriver.
Keep lowering the panel until it is completely out of the upper track and free.
Remove the door from the track.
2 pull out the rollers and the weatherstripping gasket.
Pushing the wheels up will make it easier to.
According to this old house debris build up is the main reason for a sliding door that refuses to glide.
Start with the removal of the screen door.
You will be able to tell the wheels are sufficiently.