Lift the door away from the track and set it down on a flat surface.
Swinging glass door adjustment.
Then bend the pin slightly with a firm whack.
The locking pin is then repositioned to the open hole to hold the spring tighter.
A quick adjustment of shower door level when it won t close.
Take them into the room and close the door.
Tighten the screws until they are slightly tight.
When the hex key is turned the adjustment ring is turned revealing an open hole.
Locate the spring loaded hinge access plates at the bottom of the door at its pivot point.
Pull out the pin holding the adjustment mechanism in place.
Make sure that the hinge itself is free of adhesives and caulk and use a little wd 40 on the join to help it move.
Step 1 remove the sliding glass door from the track by swinging the bottom toward the back of the shower and then lifting the door until the wheels at the top are free of the track.
Depending on the hinge you might be able to pull it out.
Twist the adjustment.
Locate the swing door s adjustment mechanism.
You can move the upper rollers so that the door is swinging a little higher in the gap and you can also fix the hinge to the shower door a little further down so that it flows freely.
Some self closing door hinges require the use of a hex key inserted in the top or bottom of the hinge to turn the adjustment ring.
This prevents the door from shifting.
Twist the adjustment screw in a.
How to adjust a swing door step 1.
Start with the bottom hinge first the top hinge second and then the middle hinge last.
How to adjust frameless glass shower door hinges.
Some doors have a mechanism on all the hinges while others have the.
If you notice leaks at the sides or bottom of the door.
Tighten the hinges again.
Frameless shower doors consist of tempered glass with two or three hinges at one side.
The door should now be fixed.
How to adjust a swing door 1.
Stick the shim loosely between the door and the jamb to hold the door in position when you drive out the upper hinge pin.
Locate the adjustment screw at the end of the large spring mounted in the hinge assembly.
